Machine Specifications : HT

 Spec 1

　

	ITEMS		UNIT	HT-30			HT-60			HT-100			HT-125
Injection Unit	Screw Type			A	B	C	A	B	C	A	B	C	A	B	C
	Screw Diameter		mm	18	20	22	22	24	26	30	34	40	34	40	44
	Screw Stroke		mm	-			-			150			180
	Theoretical shot volume		cm³	23	28	34	42	50	58	108	139	192	163	226	274
	Shot weight of injection (ps)		gram	21	26	31	38	45	53	99	128	177	150	208	251
	Injection pressure	I	kgf/cm²	3252	2634	2177	2668	2242	1911	1890	1471	1063	1938	1400	1157
	Injection speed		mm/sec	105			149.6			136			121
	Injection rate		cm³/sec	26.7	32.9	39.9	56.8	67.6	79.4	96	124	171	110	152	184
	Injection pressure	II	kgf/cm²	-			-			2481	1932	1396	2471	1785	1475
	Injection speed		mm/sec	-			-			104			95
	Injection rate		cm³/sec	-			-			73	94	130	86	119	144
Mould Clamping Unit	Mould clamping force		tonf	30			60			100			125
	Mould clamping stroke		mm	230			260			350			410
	Mould thickness		mm	100~300			120~360			100~430			120~490
	Suggested minimum mold dim. (H x V)		mm	170x170			200x200			234x234			267x267
	Distance between tie bars (H x V)		mm	260x260			310x310			355x355			405x405
	Mould platen (H x V)		mm	380x380			460x460			525x525			600x600
	Ejector stroke		mm	50			60			90			100
Electrical equipment	Max. Pump driving motor		KW	10(7.5)			15(11.2)			15(11.19)			20(14.92)
	Temperature controller		(range)set	(0-400°C)x4			(0-400°C)x4			(0-400°C)x3			(0-400°C)x4
	Heater capacity		kw	3.4			4.3			6.72			8.83
Others	Machine dimensions (L x W x H)		mm	4100x1100x1600			4300x1200x1600			4410x1250x1580			4750x1310x1670
	Oil tank capacity		liter	160			200			210			240
	Machine weight		metric tons	2			3			3.5			4.5
	Max. system pressure		kgf/cm²	140			140			140			140

* The shot weight is based on polystyene at specific gravity of 1.05 

* Due to continuous improvements, we reserve the right to amend any of the above specifications  without prior notice.

Back to Content